#Vinyl flooring installed install
#Vinyl flooring installed professional

To create a more natural look, continue installing planks using a staggered pattern. To help ensure a tight joint at the seam, use a tapping block when clicking planks together. After you’ve measured, scored, and cut that first plank, angle and connect the plank on the short side first before connecting the long sides together. When starting your second row, you’ll want to stagger it at least 8 inches from your first row. Now you have an accurately notched plank that fits around those little nooks and crannies. Then, mark the planks along the lines of the paper and use your utility knife to cut into the plank. Continue angling and clicking together your LVT until you’re done with your first row.įor any irregular cutouts that need to be notched into your planks, you can use paper to trace out the shapes. You’ll know that they are when the flooring sits flat on top of the wood or concrete subfloor. Take your second plank and angle and click them together until they’re completely locked. Place the first piece of the first row in the left-hand corner, and make sure that the tongue of the planks are facing the wall.

Place your 1/4-inch spacers around the room to allow the planks to expand and contract over time. Once you’ve marked the proper measurements on your vinyl plank flooring, use a utility knife to score it and snap off the excess piece or a floor cutter to get a clean cut. If your calculations do leave you with a smaller piece, then cut the first and last rows to be the same length or width in order to avoid only one skinny side or end piece.

To get a balanced look, avoid any length measurements less than 8 inches and width measurements less than half of the plank’s width. Both measurements need to take into account the 1/4-inch gap that you’ll leave all around the perimeter of the room. Then, measure the width of the room divided by the width of the planks. Start by measuring the length of the room divided by the length of luxury vinyl planks.

#Vinyl flooring installed professional

Step 2: Planning the Installationįor professional results, you’ll want to plan properly.

#Vinyl flooring installed install

Install any cabinets, vanities, or tubs in the space prior to laying LVT around them. Each subfloor type may require a little bit different preparations, but they all need to be as clean and level as possible so that your floating floor sits well on the surface.įor rooms with permanent fixtures, make sure to put those in place first.

Whatever you do, don’t skip these best practices for luxury vinyl tile installation. Since it’s a floating floor, LVT can be installed over a wood subfloor, concrete subfloor, or existing tile, so it’s crucial that your subfloor is solid and sound before moving on with the installation. One of the most important steps when installing vinyl flooring is preparing the surface. Follow the four steps below when adding beautiful LVT to your residential or commercial property. With an extra 10% on hand for waste, you’ll soon be flying through your installation thanks to these easy installation guidelines. Instead, place the planks in the room to reach the current temperature, which ideally should be between 65 and 85 degrees Fahrenheit.

One of the benefits of luxury vinyl tile like MSI’s Everlife Rigid Core is that it can even be installed the same day because it doesn’t need to be acclimated to the space.